Inventor of the telephone: Alexander Graham Bell
Major events in the development of the telephone
How the telephone works
Inside of a
telephone (Western Electric model)
The Telephone
How the Telephone
works
When a person speaks into a telephone, the sound waves created by his voice enter the mouthpiece.
An electric current carries the sound to the telephone of the person he is talking to. A telephone has
two main parts: (1) the transmitter and (2) the receiver. The Transmitter of a telephone serves as a sensitive "electric ear." It lies behind the mouthpiece of
the phone. Like the human ear, the transmitter has an 14 eardrum." The eardrum of the telephone is
a thin, round metal disk called a diaphragm. When a person talks into the
telephone, the sound waves strike the diaphragm and make it vibrate. The diaphragm vibrates at various speeds, depending on
the variations in air pressure caused by the varying tones of the speaker's voice.
Behind the diaphragm lies a small cup filled with tiny grains of carbon. The diaphragm presses
against these carbon grains. Low voltage electric current travels through the grains. This
current comes from batteries at the telephone company. The pressure on the carbon grains varies as sound
waves make the diaphragm vibrate. A loud sound causes the sound waves to push hard on the
diaphragm. In turn, the diaphragm presses the grains tightly together. This action makes it easier
for the electric current to travel through, and a large amount of electricity flows through the
grains. When the sound is soft, the sound waves push lightly on the diaphragm. In turn, the
diaphragm puts only a light pressure on the carbon grains. The grains are pressed together loosely.
This makes it harder for the electric current to pass through them, and less current flows through
the grains.
Thus, the pattern of the sound waves determines the pressure on the diaphragm. This pressure, in
turn, regulates the pressure on the carbon grains. The crowded or loose grains cause the electric
current to become stronger or weaker. The current copies the pattern of the sound waves and
travels over a telephone wire to the receiver of another telephone. The Receiver serves as an "electric mouth." Like a human voice, it has "vocal cords." The vocal cords
of the receiver are a diaphragm. Two magnets located at the edge of the diaphragm cause it to
vibrate. One of the magnets is a permanent magnet that constantly holds the diaphragm close to it.
The other magnet is an electromagnet. It consists of a piece of iron with a coil of wire wound around
it. When an electric current passes through the coil, the iron core becomes
magnetized. The diaphragm is pulled toward the iron core and away from the permanent magnet. The pull of the
electromagnet varies between strong and weak, depending on the variations in the current. Thus, the
electromagnet controls the vibrations of the diaphragm in the receiver. The electric current passing through the electromagnet becomes stronger or weaker according to
the loud or soft sounds. This action causes the diaphragm to vibrate according to the speaker's
speech pattern. As the diaphragm moves in and out, it pulls and pushes the air in front of it. The
pressure on the air sets up sound waves that are the same as the ones sent into the transmitter. The
sound waves strike the ear of the listener and he hears the words of the speaker.